Tuesday, November 22, 2016

Tutorial D2 - Button, led dan buzzer

1) Copy code di sini 





/*
  Button

 Turns on and off a light emitting diode(LED) connected to digital
 pin 13, when pressing a pushbutton attached to pin 2 and make a noise


 The circuit:
 * LED attached from pin 13 to ground
 * pushbutton attached to pin 2 from +5V
 * 10K resistor attached to pin 2 from ground

 * Note: on most Arduinos there is already an LED on the board
 attached to pin 13.


 created 2016
 by engrzihadmahmud

 */

// constants won't change. They're used here to
// set pin numbers:
const int buttonPin = 2;     // the number of the pushbutton pin
const int ledPin =  13;      // the number of the LED pin

// variables will change:
int buttonState = 0;         // variable for reading the pushbutton status
int peizoPin = 8;

void setup() {
  // initialize the LED pin as an output:
  pinMode(ledPin, OUTPUT);
  // initialize the pushbutton pin as an input:
  pinMode(buttonPin, INPUT);
}

void loop() {
  // read the state of the pushbutton value:
  buttonState = digitalRead(buttonPin);

  // check if the pushbutton is pressed.
  // if it is, the buttonState is HIGH:
  if (buttonState == HIGH) {
    // turn LED on:
    digitalWrite(ledPin, HIGH);
    tone(peizoPin,2000);
    delay(200);
    tone(peizoPin,1000);
    delay(200);
    tone(peizoPin,2000);
    delay(200);
    tone(peizoPin,1000);
    delay(200);
    noTone(peizoPin);
    digitalWrite(ledPin, LOW);
    delay(2000);
 
  }
  else {
    // turn LED off:
    digitalWrite(ledPin, LOW);
    noTone(peizoPin);
  }
}






2) Paste ke dalam window arduino

3) Sambungkan alatan seperti di bawah

Arduino Uno
Push Button x 1
220 ohm perintang x 2
Jumper wires
Breadboard x 1
Buzzer x 1



No comments:

Post a Comment